4
5
6
7
Move template so that front edge is ush to the front edge of bottom bar (it is okay to bend template to allow to t the shortest
width between your moulding and trim). Mark at the various corners of your existing moulding keeping in mind the shoot bolt
receiver cup (Q) is in the center of the opening so the template must be lined up accordingly, then trim.
Using box cutter, cut template to shape of moulding and trim revealed by the markings. Test t the template. (It should lay across
the bottom bar, with the front edge ush to the front edge of the bottom bar, and t in and around the corners of the existing
moulding and trim.)
Once you have created a good template, use the template to mark the threshold plate.
Using tin snips/aviator snips, cut threshold plate to match the shape of the template (6). Position threshold plate to extend across
the bottom bar and into the existing threshold. Use 1/8" drill bit to pre-drill holes for mounting screws. Attach threshold plate to
existing threshold using the provided screws.
Determining Your Build Out Area (continued)Install threshold plate (continued)
22
Page 11
Install the bottom shoot bolt receiver cup (Q) into the threshold (L). Using a
hammer or rubber mallet, gently tap the shoot bolt receiver cup into the pre-cut
hole in the threshold until ush.
Close the inactive door and deploy the shoot bolt (P) to test for proper t.
Determining Your Build Out Area (continued)Install bottom shoot bolt receiver cup
23
Place bug sweep (M) against active door and adjust
up or down until the bottom of the sweep rests
on the threshold. Attach the bug sweep using the
screws provided. Repeat process, without trimming,
for inactive door sweep. Attach bug sweeps using
white #6x5/8 pan head screws (S).
With both doors closed, position a bug sweep (M) on the
bottom of the active door against the hinge-side jamb.
Mark where the active door meets the edge of the astragal
mounted to the passive door and trim using tin snips.
Determining Your Build Out Area (continued)Install bug sweeps
24
Hold or clamp latch guard in place
even with the top of the active door
aligning with the pre-drilled mounting
holes in the door panel (B). Using a
3/32" drill bit, pre-drill holed in the
door panel through the mounting
holes in the latch guard and attach
using six white #6x5/8" pan head
screws (S).
Determining Your Build Out Area (continued)Install latch guard
25
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels